No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic RIP Functions

Configuring Basic RIP Functions

Configuring basic RIP functions includes enabling RIP, specifying network segment, and setting RIP neighbors and RIP version on a Non-Broadcast Multiple Access (NBMA) network.

Pre-configuration Tasks

Before configuring basic RIP functions, complete the following task:

  • Configuring IP addresses for interfaces to ensure network-layer communication between neighbor nodes

Configuration Procedure

Enabling RIP is the prerequisite for setting RIP neighbors and RIP version on an NBMA network.

Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 131626

Downloads: 274

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next