No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
When Configured with a Link State Protocol, Why Can the Local Device Not Establish Neighbor Relationship with the Peer Device?

When Configured with a Link State Protocol, Why Can the Local Device Not Establish Neighbor Relationship with the Peer Device?

When the local device is configured with a link state protocol, first check the type of the interface on the peer device.
  • To set the network type for an OSPF interface, run the ospf network-type command.
  • To set the network type of an IS-IS interface to P2P, run the isis circuit-type p2p command.

The network types of the interfaces on both ends of a link must be the same; otherwise, the neighbor relationship cannot be established.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 143733

Downloads: 280

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next