No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring OSPFv3 to Import External Routes

Configuring OSPFv3 to Import External Routes


OSPFv3 is a link-state routing protocol and cannot directly filter advertised LSAs, therefore OSPFv3 must filter routes when importing them. In this way, only the routes that pass the filtering criteria can be advertised.

Carry out the following steps on the router that runs OSPFv3.


  1. Run system-view

    The system view is displayed.

  2. Run ospfv3 [ process-id ]

    The OSPFv3 view is displayed.

  3. Run default { cost cost | tag tag | type type } *

    Default parameters of imported routes are set.

  4. Run import-route { bgp [ permit-ibgp ] | unr | direct | ripng help-process-id | static | isis help-process-id | ospfv3 help-process-id } [ { cost cost | inherit-cost } | type type | tag tag | route-policy route-policy-name ] *

    External routes are imported.

    Importing IBGP routes in an OSPFv3 process may lead to routing loops.

    After the import-route command is executed on an OSPFv3 router to import external routes, the router becomes an ASBR.

  5. (Optional) Run default-route-advertise [ always | cost cost | type type | tag tag | route-policy route-policy-name ] *

    Default routes are advertised to the OSPFv3 routing area.

  6. (Optional) Run filter-policy { acl6-number | acl6-name acl6-name | ipv6-prefix ipv6-prefix-name } export [ protocol [ process-id ] ]

    Imported external routes are filtered.

    To filter a certain type of routes, specify protocol. If protocol is not specified, OSPFv3 filters all imported routes.

    The filter-policy command takes effect only for the routes imported by an ASBR using the import-route command. That is, the ASBR filters routes when importing the routes. The routes that are filtered out do not generate LSAs and cannot be advertised by OSPFv3. If the import-route command is not configured to import other external routes (including OSPFv3 routes in different processes), the filter-policy command does not take effect.

Updated: 2019-12-27

Document ID: EDOC1000174069

Views: 196771

Downloads: 324

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next