No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RIP to Advertise Default Routes

Configuring RIP to Advertise Default Routes

Context

In a routing table, a default route is the route to the network segment 0.0.0.0 (with the mask being 0.0.0.0). If the destination address of a packet does not match any entry in the routing table, the packet is sent along the default route.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run rip [ process-id ]

    The RIP view is displayed.

  3. Run default-route originate [ cost cost | tag tag | { { match default | route-policy route-policy-name [ advertise-tag ] } [ avoid-learning ] } ]*

    The device is configured to originate a default route or advertise the default route in the routing table to neighbors.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 128573

Downloads: 274

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next