No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the OSPFv3 NSSA Configuration

Verifying the OSPFv3 NSSA Configuration


The configurations for OSPFv3 NSSAs are complete.


  • Run the display ospfv3 [ process-id ] area [ area-id ] command to check information about OSPFv3 areas.
  • Run the commands as follow to check the OSPFv3 routing table.

    • display ospfv3 [ process-id ] routing

    • display ospfv3 [ process-id ] routing [ abr-routes | asbr-routes | statistics | ipv6-address prefix-length | intra-routes | inter-routes | ase-routes | nssa-routes ]

Updated: 2019-12-27

Document ID: EDOC1000174069

Views: 188220

Downloads: 316

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next