No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Starting a BGP Process

Starting a BGP Process

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    BGP is started, the local AS number is specified, and the BGP view is displayed.

    After BGP peers are configured, changing the router ID of a BGP peer resets BGP peer relationships.

  3. Run router-id ipv4-address

    NOTE:

    By default, BGP automatically selects the router ID in the system view. If the IP address of a physical interface is used as the router ID, route flapping occurs when the IP address of the physical interface changes. To enhance network stability, configuring the address of a loopback interface as the router ID is recommended. For Router ID selection rules in the system view, see descriptions in Command Reference about the router-id command.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 113503

Downloads: 254

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next