No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RIP GR

Configuring RIP GR

This section describes how to configure RIP GR to avoid incorrect route calculation and packet loss after a RIP router restarts.

Pre-configuration Tasks

Before configuring RIP GR, complete the following task:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run rip [ process-id ]

    The RIP view is displayed.

  3. Run graceful-restart [ period period | wait-time time | planned-only time ] *

    RIP GR is enabled.
    NOTE:

    Only AR3200 series can function as the Restarter router.

    When most devices on a network do not support RIP GR, setting wait-time time to a larger value is recommended. This ensures that the Restarter has enough time to learn correct routes.

Verifying the Configuration

Run the display rip process-id graceful-restart [ verbose ] command to check the status of RIP GR.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 114061

Downloads: 254

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next