No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Interval for Receiving LSAs

Setting the Interval for Receiving LSAs

Context

In OSPF, the interval for receiving LSAs is 1s. This aims to prevent network connections or frequent route flapping from consuming excessive network bandwidth or device resources.

On a stable network where routes need to be fast converged, you can cancel the interval for receiving LSAs by setting the interval to 0 seconds. In this manner, changes to the topology or the routes can be immediately advertised on the network through LSAs, thereby speeding up route convergence on the network.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF process view is displayed.

  3. Run lsa-arrival-interval { interval | intelligent-timer max-interval start-interval hold-interval }

    The interval for receiving LSAs is set.

    • The parameter interval specifies the interval for receiving LSAs, in milliseconds.
    • The parameter intelligent-timer indicates that the interval for receiving router LSAs or network LSAs is set through an intelligent timer.
    • The parameter max-interval specifies the maximum interval for receiving LSAs, in milliseconds.
    • The parameter start-interval specifies the initial interval for receiving LSAs, in milliseconds.
    • The parameter hold-interval specifies the hold interval for receiving LSAs, in milliseconds.

    On a stable network where routes need to be fast converged, you can set the interval for receiving LSAs to 0 seconds so that changes to the topology or the routes can be detected immediately.

    By default, an intelligent timer is enabled. After an intelligent timer is enabled, the default maximum interval for receiving LSAs is 1000 ms, the default initial interval is 500 ms, and the default hold interval is 500 ms. Details about the interval for receiving LSAs are as follows:
    1. The initial interval for receiving LSAs is specified by the parameter start-interval.
    2. The interval for receiving LSAs for the nth (n ≥ 2) time is equal to hold-interval x 2(n-2).
    3. When the interval specified by hold-interval x 2(n-2) reaches the maximum interval specified by max-interval, OSPF receives LSAs at the maximum interval for three consecutive times. Then, OSPF goes back to step 3.a and receives LSAs at the initial interval specified by start-interval.

  4. (Optional) Run lsa-arrival-interval suppress-flapping suppress-interval [ threshold threshold ]

    The maximum LSA suppression period is configured.

    If frequent LSA flapping occurs, the larger value between lsa-arrival-interval suppress-flapping and lsa-arrival-interval is used to suppress LSA flapping.

    By default, if the device receives an LSA, it delays route calculation for 10s.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 144336

Downloads: 280

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next