No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for OSPF

Default Settings for OSPF

Table 5-20 describes the default settings for OSPF.

Table 5-20 Default settings for OSPF
Parameter Default Setting
OSPF Disabled
Interval for sending Hello packets By default, the interval for sending Hello packets is 10 seconds on P2P and broadcast interfaces; the interval is 30 seconds on P2MP and NBMA interfaces.
Dead interval for OSPF neighbors By default, the dead interval for OSPF neighbors is 40 seconds on P2P and broadcast interfaces; the interval is 120 seconds on P2MP and NBMA interfaces.
Period during which a device continues to act as a stub router 500 seconds
Bandwidth reference value used to calculate the link cost 100 Mbit/s
Updated: 2019-12-27

Document ID: EDOC1000174069

Views: 198536

Downloads: 354

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next