No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring BGP Route Selection and Load Balancing

Configuring BGP Route Selection and Load Balancing

BGP has many route attributes. These attributes can be configured to change the route selection result.

Pre-configuration Tasks

Before configuring BGP route attributes, complete the following task:

Configuration Procedure

Perform the following configuration tasks as required. The following configuration tasks (excluding the task of Verifying the BGP Route Selection and Load Balancing Configuration) can be performed in any sequence. For detailed route selection rules, see BGP Route Selection Rules and Load Balancing.

Updated: 2019-12-27

Document ID: EDOC1000174069

Views: 188369

Downloads: 316

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next