Rate and give feedback
:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Local PBR
Pre-configuration Tasks
Before configuring local SPR, complete the following tasks:
Setting link layer protocol parameters for interfaces to ensure that the link layer protocol status on the interfaces is Up
Configuring an ACL to match packets
Creating a VPN instance if you want packets to be forwarded by a VPN instance
NOTE: Local PBR applies only to locally generated packets.
When the local policy-based routing and the fast ICMP reply function are configured at the same time, the local policy-based routing function does not take effect for ICMP packets. Therefore, if the local policy-based routing function is configured on the device, you are advised to disable the fast ICMP reply function.
Previous
