No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Interval for Sending Hello Packets

Configuring the Interval for Sending Hello Packets

Context

Hello packets are periodically sent to the neighbor router to detect and maintain the neighbor relationship and to elect the DR and the BDR. RFC 2328 requires that the Hello timer values of neighbors be consistent. The value of the Hello timer is inversely proportional to the route convergence speed and network load.

Do as follows on the router that runs OSPFv3.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run ospfv3 timer hello interval [ instance instance-id ]

    The interval for sending Hello packets is set on the interface.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 113280

Downloads: 254

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next