No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling IS-IS Auto FRR

Enabling IS-IS Auto FRR

Context

At present, the VoIP and on-line video services require high-quality real-time transmission. Nevertheless, if an IS-IS fault occurs, multiple processes, including fault detection, LSP update, LSP flooding, route calculation, and FIB entry delivery, must be performed to switch the traffic to a new link. As a result, it takes much more than 50 ms to recover the link from the fault, which cannot meet the requirement for real-time services on the network.

After the BFD session status is bound to IS-IS Auto FRR, traffic can be fast switched from the faulty link to the backup link. This ensures that the traffic interruption time is within 50ms, which protects traffic and improves IS-IS network reliability.

NOTE:

AR100&AR120&AR150&AR160&AR200 series routers do not support IS-IS Auto FRR.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run isis [ process-id ]

    The IS-IS process is enabled and the IS-IS view is displayed.

  3. Run frr

    The IS-IS FRR view is displayed.

  4. (Optional) Run frr-policy route route-policy route-policy-name

    Backup routes are filtered using a filtering policy. Only backup routes that have passed the filtering policy are added to the routing table.

  5. Run loop-free-alternate [ level-1 | level-2 | level-1-2 ]

    IS-IS Auto FRR is enabled and the loop-free backup route is created.

    By default, IS-IS Auto FRR is disabled from calculating loop-free backup routes using the loop-free alternate (LFA) algorithm.

    If the IS-IS level is not specified, IS-IS Auto FRR is enabled on Level-1 and Level-2 to create the backup route.

  6. (Optional) Run the following command in the interface view:

    • undo isis lfa-backup [ level-1 | level-2 | level-1-2 ]

    The interface is disabled from participating in LFA calculation.

    By default, an IS-IS interface can participate in LFA calculation.

    During network deployment, to facilitate traffic management and fast determine the traffic forwarding path when the primary link fails, disable some interfaces from participating in LFA calculation.

Verifying the Configuration

  • Run the display isis route [ process-id | vpn-instance vpn-instance-name ] [ ipv4 ] [ verbose | [ level-1 | level-2 ] | ip-address [ mask | mask-length ] ] * command to check information about the primary link and backup link generated by IS-IS Auto FRR.
  • Run the display isis spf-tree verbose command to check the traffic protection type of IS-IS Auto FRR.
Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 143702

Downloads: 280

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next