No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Unicast Routing

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling OSPFv3 on an Interface

Enabling OSPFv3 on an Interface

Context

After enabling OSPFv3 in the system view, you need to enable OSPFv3 on the interface.

Because an interface has multiple instances, you need to specify which instance of the interface is enabled in the OSPFv3 process when OSPFv3 is enabled on the interface. If no instance ID is specified, the value defaults to 0. The same instance must be enabled on the interfaces between which the neighbor relationship is set up.

Do as follows on the router that runs OSPFv3.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run ospfv3 process-id area area-id [ instance instance-id ]

    OSPFv3 is enabled on the interface.

    The area ID can be a decimal integer or in the IPv4 address format, but it is displayed in the IPv4 address format.

  4. (Optional) Run the ospfv3 network-type { broadcast | nbma | p2mp [ non-broadcast ] | p2p } [ instance instance-id ] command to configure the network type of an interface.

    NOTE:

    When an interface supports multi-instances, you must specify the value of instance-id when enabling OSPFv3 on the interface. If the value of instance-id is not specified, the default value 0 is adopted. In this case, the configured network type of an interface mismatches the actual network type of the interface. This step is mandatory in such a case.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174069

Views: 132453

Downloads: 274

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next