Enabling OSPFv3 on an Interface
Context
After enabling OSPFv3 in the system view, you need to enable OSPFv3 on the interface.
Because an interface has multiple instances, you need to specify which instance of the interface is enabled in the OSPFv3 process when OSPFv3 is enabled on the interface. If no instance ID is specified, the value defaults to 0. The same instance must be enabled on the interfaces between which the neighbor relationship is set up.
Do as follows on the router that runs OSPFv3.
Procedure
- Run system-view
The system view is displayed.
- Run interface interface-type interface-number
The interface view is displayed.
- Run ospfv3 process-id area area-id [ instance instance-id ]
OSPFv3 is enabled on the interface.
The area ID can be a decimal integer or in the IPv4 address format, but it is displayed in the IPv4 address format.
- (Optional) Run the ospfv3 network-type { broadcast | nbma | p2mp [ non-broadcast ] | p2p } [ instance instance-id ] command to configure the network type of an interface.
When an interface supports multi-instances, you must specify the value of instance-id when enabling OSPFv3 on the interface. If the value of instance-id is not specified, the default value 0 is adopted. In this case, the configured network type of an interface mismatches the actual network type of the interface. This step is mandatory in such a case.