No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ICMP Jitter Test

ICMP Jitter Test

The ICMP jitter test uses ICMP packets to determine the delay, jitter, and packet loss ratio based on the timestamps in test packets. Jitter is the interval for receiving two consecutive packets minus the interval for sending the two packets.

The ICMP jitter test process is as follows:

  1. The source (RouterA) sends packets to the destination (RouterB) at a specified interval.

  2. The destination receives the packets, adds a timestamp to them, and sends them back to the source.

  3. The source receives the packets and calculates the jitter by subtracting the interval at which consecutive packets are sent from the interval at which the destination receives them.

Figure 7-5  Network for ICMP jitter test
The following indexes are calculated based on the information received from the source:
  • The maximum, minimum, and average jitter of the packets from the source to the destination and from the destination to the source.

  • The maximum unidirectional delay from the source to the destination or from the destination to the source.

ICMP jitter test results and historical records are collected in test instances. You can run commands to view the test results and historical records.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174072

Views: 103526

Downloads: 343

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next