No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring NetStream Statistics Collection

Configuring NetStream Statistics Collection

Context

IPv4 original flow statistics can be exported only if flow statistics collection is enabled on an interface.

If you configure interface-based flow statistics collection and traffic policy-based flow statistics collection simultaneously on one direction of the same interface, one packet is collected only once.

Procedure

  • Configuring interface-based flow statistics collection
    1. Run system-view

      The system view is displayed.

    2. (Optional) Run ip netstream pre-classify enable

      The pre-classify function is enabled globally.

      By default, the pre-classify function is disabled globally.

    3. Run interface interface-type interface-number [.subinterface-number ]

      The interface view is displayed.

    4. Run ip netstream { inbound | outbound }

      The NetStream function is enabled on the interface to collect statistics about IPv4 flows.

      By default, the NetStream function for IPv4 flows is disabled on the interface.

  • Configuring traffic policy-based flow statistics collection
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number [.subinterface-number ]

      The interface view is displayed.

    3. Run traffic-policy policy-name { inbound | outbound }

      The traffic policy is applied to the inbound or outbound direction on the interface.

      By default, no traffic policy is applied to an interface.

    Before applying a traffic policy to an interface, configure one according to Configuring NetStream Sampling.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174072

Views: 103568

Downloads: 343

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next