No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).


The NQA Simple Network Management (SNMP) test is performed using UDP. It measures the time taken for communication between an NQA client and an SNMP agent.

The SNMP test process is as follows:

  1. The source (RouterA) sends a request packet to the SNMP agent (RouterC) to obtain the system time.

  2. Upon receiving the request packet, the SNMP agent queries the system time, constructs a reply packet, and sends it to the source.

    After receiving the reply packet, the source calculates the time taken for communication between the source and the SNMP agent by subtracting the time the source sends the request packet from the time the source receives the reply packet. The test result reflects SNMP performance on the network.

Figure 7-9  Network for SNMP test

SNMP test results and historical records are collected in test instances. You can run commands to view the test results and historical records.

Updated: 2019-05-17

Document ID: EDOC1000174072

Views: 108030

Downloads: 346

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next