No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring NetStream Original Flow Statistics Exporting

Configuring NetStream Original Flow Statistics Exporting

Context

Original flow statistics can be exported only when you have specified at least one destination IP address and one destination UDP port number for the exported packets.

Procedure

  1. Run the system-view command to enter the system view.
  2. (Optional) Run ip netstream as extend enable

    The supported BGP AS number range is set.

    By default, the BGP AS numbers range from 1 to 65535.

    Only the output packets of V9 or V10 support the 32-bit BGP AS numbers. The ip netstream as extend enable command needs to be executed to set the supported BGP AS number range to 1-4294967295.

  3. Run the ip netstream export source ip-address command to configure the source address of the exported packets carrying original flow statistics.

    By default, the source IP address of the exported packets carrying IPv4 flow statistics is not configured.

  4. Run the ip netstream export host ip-address port-number [ vpn-instance vpn-instance-name ] command to configure the destination IP address and destination UDP port number of the exported packets carrying original flow statistics.

    You can configure two destination IP addresses to implement NSC backup. To configure a third destination IP address, run the undo ip netstream export host command to delete an existing one first; otherwise, the system displays a message indicating that the maximum number of IP addresses is exceeded and the configuration fails.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174072

Views: 100726

Downloads: 333

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next