No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring NetStream Statistics Collection

Configuring NetStream Statistics Collection

Context

IPv4 multicast original flow statistics can be exported only when you have enabled the flow statistics collection function on an interface.

If you configure interface-based flow statistics collection and traffic policy-based flow statistics collection simultaneously on one direction of the same interface, one packet is collected only once.

Procedure

  • Configuring interface-based flow statistics collection
    1. Run system-view

      The system view is displayed.

    2. (Optional) Run ip netstream pre-classify enable

      The pre-classify function is enabled globally.

      By default, the pre-classify function is disabled globally.

    3. Run interface interface-type interface-number [.subinterface-number ]

      The interface view is displayed.

    4. Run ip netstream multicast { inbound | outbound }

      The NetStream function is enabled on the interface to collect statistics about IPv4 multicast flows.

      By default, NetStream is disabled for multicast flows.

      The NetStream function supports independent statistics about incoming and outgoing packets at the same time.

  • Configuring traffic policy-based flow statistics collection
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number [.subinterface-number ]

      The interface view is displayed.

    3. Run traffic-policy policy-name { inbound | outbound }

      The traffic policy is applied to the inbound or outbound direction on the interface.

      By default, no traffic policy is applied to an interface.

    Before applying a traffic policy to an interface, configure one according to Configuring NetStream Sampling.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174072

Views: 101197

Downloads: 335

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next