No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Device to Communicate with an NMS by Running SNMPv1

Configuring a Device to Communicate with an NMS by Running SNMPv1

Context

To allow a device to communicate with an NMS running SNMPv1, configure SNMPv1 on the device. The SNMP parameters must be configured on both the managed device (agent) and NMS. This section describes only the SNMP configurations on the agent side. For details about SNMP configurations on an NMS, see the NMS operation guide.

A lack of authentication capabilities in SNMPv1 and SNMPv2c results in vulnerability to security threats, so SNMPv3 is recommended.

Pre-configuration Tasks

Before configuring the router to communicate with an NMS through SNMPv1, configure a routing protocol to ensure that a reachable route exists between the router and NMS.

Configuration Process

When you configure the router to communicate with the NMS using SNMPv1, only Configuring Basic SNMPv1 Functions is mandatory and the optional steps are performed in any sequence.

After the SNMP basic functions are configured, the router and NMS can communicate with each other.
  • The NMS using the specified community name can access the Viewdefault view. The internet MIB (OID: 1.3.6.1) and the lagMIB (OID: 1.2.840.10006.300.43) can be operated in this view.

  • The managed device sends traps generated by the modules that are enabled by default to the NMS.

The following are more configurations related to SNMPv1:
  • To allow the NMS that uses the specified community name to manage specified objects on the device, perform the operations in Restricting Management Rights of the NMS.

  • To allow a specified module on the managed device to report traps to the NMS, perform the operations in Configuring the Trap Function.

  • If the NMS and managed device are both Huawei products, perform the operations in Enabling the SNMP Extended Error Code Function to allow the device to send more types of error codes. This allows more specific error identification and facilitates your fault location and rectification.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174072

Views: 109605

Downloads: 346

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next