No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring LSDP

Configuring LSDP


You can configure LSDP on an interface that has an IP address and route configured.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run lsdp ip-address [ nexthop-address ] [ interval interval-number ] [ probe-count count number ]

    LSDP is configured

Verifying the Configuration

Run the display lsdp command to view the LSDP configuration and running status.

Updated: 2019-05-17

Document ID: EDOC1000174072

Views: 100020

Downloads: 331

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next