No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration

Verifying the Configuration

This section describes how to view the configuration and status of the MCP, DCPs, and TLPs to check whether IP FPM end-to-end performance measurement is configured successfully.


Configurations of IP FPM end-to-end performance measurement have been completed.


  • Run the display ipfpm mcp command to check the MCP configuration and status in the IP FPM system.
  • Run the display ipfpm dcp command to check the DCP configuration in the IP FPM system.
  • Run the display ipfpm statistic-type { loss | twoway-delay } instance instance-id command to check performance statistics in a specified IP FPM instance in the IP FPM system.
  • Run the display ipfpm instance application command to view information about the applications detected in IP FPM instances.
Updated: 2019-05-17

Document ID: EDOC1000174072

Views: 109798

Downloads: 348

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next