No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
PWRUTITHRESH

PWRUTITHRESH

Description

HUAWEI POE/PWRUTITHRESH: PoE power is not enough to power on all the PD.Some low priority PD may power off.(ConsumingPower=[integer])

The current consumed power is higher than the alarm threshold.

Attribute

Alarm ID Alarm Severity Alarm Type
None None None

Parameters

Name Meaning
ConsumingPower Indicates the current consumed power.

Impact on the System

Low-priority PDs will be powered off.

Possible Causes

The current consumed PoE power is higher than the alarm threshold.

Procedure

  1. Run the display poe-power command to check the total power of PDs connected to all ports. If the total power approximates the maximum output power of the PoE midspan, the PoE midspan cannot provide sufficient power for the PDs and new PoE midspans need to be added.
  2. Increase priorities of important devices to prevent their power from being occupied.

Related Information

None

Translation
Download
Updated: 2019-05-06

Document ID: EDOC1000174085

Views: 117599

Downloads: 19

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next