Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
IPFPM_1.3.6.1.4.1.2011.5.25.316.3.8 hwIpfpmTlpExceed
Attribute
| Alarm ID | Alarm Severity | Alarm Type |
|---|---|---|
1.3.6.1.4.1.2011.5.25.316.3.8 |
Major |
qualityOfServiceAlarm(3) |
Parameters
| Name | Meaning |
|---|---|
oid |
Indicates the MIB object ID of the alarm. |
BoardIndex |
Board index |
BoardTlpNumber |
Number of TLPs configured on a board |
ThresholdValue |
Number of TLPs allowed by a board |
Impact on the System
The number of TLPs configured on a board exceeded the TLP threshold of the board, consuming more board resources. Therefore, the board processing performance is affected.
Procedure
- Check whether the TLPs on a board are
normally configured.
- If so, go to Step 2.
- If not, go to Step 3.
- Check whether the normally configured TLPs are referenced
by services in the DCP view.
- If so, go to Step 5.
- If not, go to Step 4.
- Delete the TLPs that are incorrectly configured and check
whether the trap persists.
- If so, go to Step 2.
- If not, go to Step 6.
- Delete TLPs that are not referenced by services. Run the display ipfpm dcp command to check the maximum number of TLPs that the board supports. Ensure that the number of TLPs configured
on the board is smaller than the maximum number
of TLPs that the board supports and check whether
the trap persists.
- If so, go to Step 5.
- If not, go to Step 6.
- Collect alarm information and configuration information, and then contact technical support personnel.
- End.
Previous
