No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
AM_1.3.6.1.4.1.2011.6.8.2.2.0.6 hwUsedIPReachThreshold

AM_1.3.6.1.4.1.2011.6.8.2.2.0.6 hwUsedIPReachThreshold

Description

AM/4/IPPOOLUSEDOUT: OID [OID] The number of used addresses exceeds alarm threshold. (PoolName=[OCTET], UsedPercentage=[OCTET])

The number of used addresses in the IP address pool exceeded the alert threshold.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.6.8.2.2.0.6 Warning equipmentAlarm(5)

Parameters

Name Meaning

OID

Indicates the MIB object ID of the alarm.

PoolName

Address pool name.

UsedPercentage

Usage percentage of allocatable IP addresses.

Impact on the System

IP addresses may fail to be allocated.

Possible Causes

The percentage of used addresses in the IP address pool exceeded the alert threshold.

Procedure

  • Add more allocatable IP addresses to the address pool by reducing the mask length. Run the ip address ip-address { mask | mask-length } command in the interface view to reduce the mask length. Alternatively, run the network ip-address [ mask { mask | mask-length } ] command in the global address pool view to reduce the mask length.
  • If an IP address segment is configured in the address pool, add more allocatable IP addresses to the address pool by increasing the range of the IP address segment. Run the dhcp server ip-range start-ip-address end-ip-address command in the interface view to increase the range of IP addresses. Alternatively, run the section section-id start-address [ end-address ] command in the global address pool view to increase the range of IP addresses.

Related Information

None

Translation
Download
Updated: 2019-05-06

Document ID: EDOC1000174085

Views: 131535

Downloads: 20

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next