No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
RM_1.3.6.1.4.1.2011.5.25.145.25.1 hwNhmRestrain

RM_1.3.6.1.4.1.2011.5.25.145.25.1 hwNhmRestrain

Description

RM/2/RM_NHM_RESTRAIN:OID [oid] Cyclic iteration was suppressed. (Type=[Integer], key=[Integer], VpnInstanceName=[octet], Nexthop=[octet])

Cyclic iteration was suppressed.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.145.25.1

Major

qualityOfServiceAlarm

Parameters

Name Meaning

oid

Indicates the MIB object ID of the alarm.

Type

Type of cyclic iteration that is suppressed

key

Key of cyclic iteration that is suppressed

VpnInstanceName

Name of the VPN to which the next hop obtained after iteration belongs

Nexthop

Next hop obtained after iteration

Impact on the System

The CPU usage will remain high if the cyclic iteration problem is not resolved.

Possible Causes

Cause 1:

A configuration error occurred.

Cause 2:

An error occurred in network deployment.

Cause 3:

BGP packets were modified.

Procedure

  1. Perform the following operation based on the value of the Type parameter:

    • If the value is 1 (route iteration) or 2 (tunnel iteration), run the display ipv4 nexthop-indirection command to check the IPv4 next hop information.

    • If the value is 3 (IPv6 route iteration), run the display ipv6 nexthop-indirection command to check the IPv6 next hop information.

    Check the value of the Protocol field.
    • If the value is BGP, run the display bgp nexthop ipv4-address command, collect all the displayed information, and contact technical support personnel. The ipv4-address parameter indicates the IP address of the next hop with cyclic iteration.
    • If the value is not BGP, contact technical support personnel.

Translation
Download
Updated: 2019-05-06

Document ID: EDOC1000174085

Views: 117305

Downloads: 19

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next