No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
SOCKET_1.3.6.1.4.1.2011.5.25.34.2.1 hwTCPMD5AuthenFail

SOCKET_1.3.6.1.4.1.2011.5.25.34.2.1 hwTCPMD5AuthenFail

Description

SOCKET/4/TCP_MD5_FAIL:OID [oid] MD5 authentication failed. (SourceAddress=[IPADDR], SourcePort=[INTEGER], ForeignAddress=[IPADDR], ForeignPort=[INTEGER], Protocol=[OCTET], VrfName=[OCTET])

The MD5 authentication of the TCP connection failed.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.34.2.1 Warning communicationsAlarm(2)

Parameters

Name Meaning

oid

Indicates the MIB object ID of the alarm.

SourceAddress

Indicates the local IP address of the TCP connection.

SourcePort

Indicates the local port number.

ForeignAddress

Indicates the destination IP address of the TCP connection.

ForeignPort

Indicates the destination port number.

Protocol

Indicates the name of the upper layer protocol.

VrfName

Indicates the VRF name.

Impact on the System

The TCP connection cannot be set up normally and upper layer protocols such as LDP and BGP cannot set up sessions.

Possible Causes

1: The MD5 authentication passwords on the two ends of the TCP connection were inconsistent.

2: Only one end of the TCP connection was configured with the MD5 authentication password.

Procedure

  • Run the display current-configuration command on the devices at the two ends of the TCP connection to check whether the devices are configured with MD5 authentication passwords.

    • Only one device is configured with the MD5 authentication password. Configure the MD5 authentication password for the other devices and ensure that the MD5 authentication passwords on the two devices must be the same, and then go to Step 3.

    • If the two devices are configured with MD5 authentication passwords but the passwords are different, go to Step 2.

  • Reconfigure the MD5 authentication passwords to make the MD5 authentication passwords consistent on the two ends of the TCP connection, and then go to Step 3.
  • Check whether the MD5 authentication is successful.

    • If so, go to Step 4.

    • If not, go to Step 5.

  • Collect alarm information and configuration information, and then contact technical support personnel.
  • End.

Related Information

None

Translation
Download
Updated: 2019-05-06

Document ID: EDOC1000174085

Views: 132267

Downloads: 20

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next