No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


MIB Reference

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Device to Communicate with an NMS Using SNMP

Configuring a Device to Communicate with an NMS Using SNMP

To ensure that a device and an NMS can communicate with each other, you need to configure communication parameters of the device and NMS. This section describes only the parameter configuration of the device. For details on how to set NMS-side parameters, refer to the NMS documentation.

Pre-configuration Tasks

Before configuring a device and an NMS to communicate with each other using SNMP, complete the following task:

  • Configuring a routing protocol to ensure that there is a reachable route between the device and NMS
Updated: 2019-07-19

Document ID: EDOC1000174090

Views: 507643

Downloads: 49

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next