No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


MIB Reference

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).


This table lists MSDP mesh group configurations.

The indexes of this table are msdpMeshGroupName and msdpMeshGroupPeerAddress.


Object Name


Max Access


Implemented Specifications


DisplayString (SIZE(1..64))


The name of the mesh group.

The value is a string of 1 to 64 characters.

This object is implemented as defined in the corresponding MIB files.




A peer address that is a member of the mesh group with name msdpMeshGroupName.

This object is implemented as defined in the corresponding MIB files.




This entry's status, by which new entries may be added to the table and old entries deleted.
  • 1: active
  • 6: destroy

Currently, the Set operation supports CreateAndGo and Destroy.

When you perform the Set operation on the object, only the value within the range from the "!" character to the "~" character, corresponding to ANSIC codes from 33 to 126, is allowed.

Creation Restriction

An entry can be created successfully when msdpPeerTable has a corresponding row. This table supports only CreateAndGo. You must set msdpMeshGroupName, msdpMeshGroupPeerAddress, and msdpMeshGroupStatus together to succeed in creating a row.

The value range of msdpMeshGroupName supported by the MIB protocol is 1 to 64 but the command line supports only 1 to 32. Therefore, when the length of msdpMeshGroupName is set to be longer than 32, only the first 32 characters take effect.

Modification Restriction

The entries in this table can be read without restriction.

Deletion Restriction

The entries in this table can be deleted without restriction.

Access Restriction

The entries in this table can be read only when MSDP is enabled and the peer is specified for the member in the mesh group.

Updated: 2019-07-19

Document ID: EDOC1000174090

Views: 512180

Downloads: 49

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next