No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Link Aggregation in Manual Mode

Link Aggregation in Manual Mode

Link aggregation can work in manual or static LACP mode depending on whether LACP is used.

In manual mode, you must manually create an Eth-Trunk and add member interfaces to the Eth-Trunk. In this mode, LACP is not required. The manual mode applies to the scenario where a high link bandwidth between two directly connected devices is required but the remote device does not support the LACP protocol. This mode can increase bandwidth, enhance reliability, and implement load balancing.

As shown in Figure 2-2, an Eth-Trunk is created between DeviceA and DeviceB. In manual mode, three active links participate in data forwarding and load balance traffic. When one link becomes faulty, the remaining two links load balance traffic.

Figure 2-2  Link aggregation in manual mode
Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 56717

Downloads: 42

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next