No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Port to Communicate with a Voice Device of Another Vendor

(Optional) Configuring a Port to Communicate with a Voice Device of Another Vendor

Context

The switch can encapsulate voice VLAN information into LLDPDUs and send them to connected IP phones. However, IP phones of some vendors send Cisco Discovery Protocol (CDP) packets. You can run the voice-vlan legacy enable command to enable CDP-compatible function so that the switch encapsulates voice VLAN information in CDP packets and sends them to connected IP phones.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run voice-vlan legacy enable

    The port is configured to communicate with a voice device of another vendor.

    By default, ports on Huawei devices cannot communicate with voice devices of other vendors.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 55891

Downloads: 41

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next