No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of the Access of a Sub-interface to an L2VPN Network

Verifying the Configuration of the Access of a Sub-interface to an L2VPN Network

Procedure

  • Run the display dot1q information termination [ interface interface-type interface-number [.subinterface-number ] ] command to check the Dot1q sub-interface configuration.
  • Run the display qinq information termination [ interface interface-type interface-number [.subinterface-number ] ] command to check the QinQ sub-interface configuration.
  • Run the display vll ccc [ ccc-name | type local ] command to check information about a CCC connection.
  • Run the display mpls static-l2vc command to check information about an SVC L2VPN VC.
  • Run the display mpls l2vc command on a PE to check information about the Martini VLL on the PE.
  • Run the display mpls l2vc remote-info command on a PE to check information about the Martini VLL on the remote PE.
Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 55174

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next