No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MSTP

Enabling MSTP

Context

After configuring basic MSTP functions on a switching device, enable MSTP function.

After MSTP is enabled on a ring network, it immediately calculates spanning trees on the network. Configurations on the switching device, such as, the switching device priority and port priority, will affect spanning tree calculation. Any change to the configurations may cause network flapping. Therefore, to ensure rapid and stable spanning tree calculation, perform basic configurations on the switching device and its ports and enable MSTP.

Procedure

  • Enable MSTP on a switching device.
    1. Run system-view

      The system view is displayed.

    2. Run stp enable

      MSTP is enabled on the switching device.

      By default, MSTP is enabled on a router.

  • Enable MSTP on an interface device.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

    3. Run stp enable

      MSTP is enabled on the interface.

      By default, MSTP is enabled on the interface.

Follow-up Procedure

When the topology of a spanning tree changes, the forwarding paths to associated VLANs are changed. The ARP entries corresponding to those VLANs on the switching device need to be updated. MSTP processes ARP entries in either fast or normal mode.

  • In fast mode, ARP entries to be updated are directly deleted.

  • In normal mode, ARP entries to be updated are rapidly aged.

    The remaining lifetime of ARP entries to be updated is set to 0. The switching device rapidly processes these aged entries. If the number of ARP aging probe attempts is not set to 0, ARP implements aging probe for these ARP entries.

You can run the stp converge { fast | normal } command in the system view to configure the STP/RSTP convergence mode.

By default, the normal MSTP convergence mode is used.

NOTE:

The normal mode is recommended. If the fast mode is adopted, ARP entries will be frequently deleted, causing the CPU usage on device to reach 100%. As a result, network flapping will frequently occur.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 56555

Downloads: 42

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next