No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Link Aggregation Configuration

Verifying the Link Aggregation Configuration

Procedure

  • Run the display eth-trunk [ trunk-id [ interface interface-type interface-number | verbose ] ] command to check the Eth-Trunk configuration.
  • Run the display trunkmembership eth-trunk trunk-id command to check information about Eth-Trunk member interfaces.
  • Run the display trunk resource command to check Eth-Trunk resources that have been used on a device.
Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 56434

Downloads: 42

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next