No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Load Balancing Mode

(Optional) Configuring a Load Balancing Mode

Context

Perform the following steps on the device to configure a load balancing mode for an Eth-Trunk.

NOTE:

The AR100–S&AR110–S&AR120–S&AR150–S&AR160–S series, AR1220E-S, AR1220C-S, AR2220E-S, AR2240C-S do not support configuring the load balancing mode.

The 4GE-2S, 4ES2G-S, 4ES2GP-S, and 9ES2 cards do not support the load balancing mode configuration.

Procedure

  • Configure a Layer 2 Eth-Trunk.
    1. Run system-view

      The system view is displayed.

    2. Run load-balance { dst-ip | dst-mac | src-ip | src-mac | src-dst-ip | src-dst-mac }

      A load balancing mode is configured for the Eth-Trunk.

      By default, the load balancing mode of a Layer 2 Eth-Trunk is src-dst-mac.

      Eth-Trunk member interfaces use flow-based load balancing. The local and remote ends can use different load balancing modes, without affecting each other.

      NOTE:

      All Layer 2 Eth-Trunks in the system must use the same load balancing mode. If the load balancing mode of one Eth-Trunk is changed, all the other Eth-Trunks use the new load balancing mode and do not support the dst-ip, src-ip and src-dst-ip parameters.

  • Configure a Layer 3 Eth-Trunk.
    1. Run system-view

      The system view is displayed.

    2. Run interface eth-trunk trunk-id

      The Eth-Trunk interface view is displayed.

    3. Run load-balance { dst-ip | dst-mac | src-ip | src-mac | src-dst-ip | src-dst-mac }

      A load balancing mode is configured for the Eth-Trunk.

      By default, the load balancing mode of a Layer 3 Eth-Trunk is src-dst-ip.

      Eth-Trunk member interfaces use flow-based load balancing. The local and remote ends can use different load balancing modes, without affecting each other.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 56641

Downloads: 42

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next