No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Dot1q Termination Sub-interface

Configuring a Dot1q Termination Sub-interface

Context

When a VPN connects to an ISP network through a sub-interface, the sub-interface needs to remove VLAN tags of the packets that the VPN has sent to the ISP network. When each packet that CEs send to PEs carries one VLAN tag, the sub-interface terminates the single VLAN tag. This sub-interface is called Dot1q termination sub-interface.

Procedure

  1. On the PE device, run:

    system-view

    The system view is displayed.

  2. Run interface interface-type interface-number.subinterface-number

    The view of the sub-interface connecting the PE to the CE is displayed.

  3. Run dot1q termination vid low-pe-vid [ to high-pe-vid ]

    Dot1q termination is configured on the sub-interface.

    NOTE:
    • high-pe-vid is supported by only the AR3200-S.

    • You can specify high-pe-vid only after the termination-vid batch enable command is used to enable a sub-interface to batch terminate VLAN tags.

    • The value of high-pe-vid must be greater than or equal to the value of low-pe-vid.

    • When this command is executed on an Eth-Trunk sub-interface, you cannot specify high-pe-vid.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 62483

Downloads: 50

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next