No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of QinQ Configuration Tasks

Summary of QinQ Configuration Tasks

Table 8-2 describes the QinQ configuration tasks.

Table 8-2  QinQ configuration tasks
Scenario Description Task

Configure QinQ tunneling

This section describes how to configure QinQ tunneling, including basic QinQ and selective QinQ.

Configuring QinQ Tunneling

Configure a sub-interface to connect to an L2VPN

CEs connect to an ISP network through PEs, and service data packets sent by a CE to a PE contain one or two tags. You need to connect sub-interfaces on PEs to a L2VPN so that CEs can communicate with each other.

Configuring a VLAN Tag Termination Sub-interface to Connect to an L2VPN

Configure a sub-interface to connect to an L3VPN

CEs connect to an ISP network through PEs, and service data packets sent by a CE to a PE contain one or two tags. You need to connect sub-interfaces on PEs to an L3VPN so that CEs can communicate with each other.

Configuring a VLAN Tag Termination Sub-interface to Connect to an L3VPN

Set the TPID value in an outer VLAN tag

To enable interoperation between devices from different vendors, set the same TPID value in outer VLAN tags on the devices.

Configuring the TPID Value in an Outer VLAN Tag

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 62666

Downloads: 51

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next