No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Transparent Bridge

Configuring a Transparent Bridge

Context

To configure Layer 2 protocol transparent transmission, you need to configure a bridge group and add user-side and network-side interfaces of a PE to the bridge group.

Perform the following steps on the PE.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bridge bridge-id

    A bridge group is created and the bridge group view is displayed.

    By default, no bridge group is configured.

  3. Run quit

    Return to the system view.

  4. Add a user-side interface to the bridge group.
    1. Run interface interface-type interface-number

      The interface view is displayed.

    2. Run bridge bridge-id

      The interface is added to the bridge group.

      By default, no interface is added to the bridge group.

  5. Repeat step 4 to add a network-side interface to the bridge group.
Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 62506

Downloads: 50

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next