No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
VLAN ID Transparent Transmission

VLAN ID Transparent Transmission

Packet VLAN IDs need to be transmitted between multiple bridged LANs so that devices in different VLANs can be isolated and those in the same VLAN can communicate with each other. VLAN ID transparent transmission can prevent VLAN IDs from being dropped during transmission.

Figure 15-8  Networking diagram for VLAN ID transparent transmission

If two trunk interfaces are connected over Ethernet, configuring VLAN ID transparent transmission prevents the transmission devices on the Ethernet from removing VLAN IDs of the packets. The two trunk interfaces can be considered as directly connected. For example, in Figure 15-8 VLAN ID transparent transmission is enabled on the interfaces of Router A and Router B, allowing PC1 and PC2 to communicate with each other.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 62091

Downloads: 49

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next