No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Closed-Ring Networking

Closed-Ring Networking

As shown in Figure 13-10, Router1 to Router5 form a dual-homed link to access a Layer 2 network. Router1 and Router5at the edge of the Layer 2 network are directly connected. This networking is called closed-ring networking. The networking is at the aggregation layer and is used to aggregate Layer 2 unicast and multicast services. When SEP runs at the aggregation layer, redundancy protection switching can be implemented at the aggregation layer and the topology of the SEP segment can be displayed.

On a closed-ring network, two edge interfaces are located on the same edge device.

Figure 13-10  Networking diagram of a closed ring running SEP

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 55428

Downloads: 41

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next