No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the Operation of Bridge Groups

Monitoring the Operation of Bridge Groups

Context

During routine maintenance, you can run the following commands in any view to monitor the operation of bridge groups.

Procedure

  • Run the display bridge traffic [ bridge bridge-id | interface interface-type interface-number ] command in any view to check whether the traffic statistics on a bridge group have been cleared.
  • Run the display bridge [ bridge-id ] information command in any view to check information about a bridge group.
  • Run the display interface bridge-if [ bridge-id ] command in any view to check information about the Bridge-if interface of a specified bridge group, including the protocol status, interface description, and IP address.
  • Run the display mac-address [ mac-address | blackhole | static | dynamic ] [ bridge bridge-id ] [ verbose ] command in any view to check the static, dynamic, or blackhole MAC address entry of a specified bridge group.
  • Run the display mac-address [ mac-address | interface-type interface-number ] bridge bridge-id [ verbose ] command or display mac-address { static | dynamic } [ interface-type interface-number ] bridge bridge-id verbose command in any view to check the static or dynamic MAC address entry of a specified bridge group and interface.
Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 55941

Downloads: 41

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next