No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a QinQ VLAN Tag Termination Sub-interface

Configuring a QinQ VLAN Tag Termination Sub-interface

Context

A QinQ VLAN tag termination sub-interface can terminate double-tagged user packets. Perform the following operations on a user-side interface of a PE.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface { ethernet | gigabitethernet } interface-number.subinterface-number

    The Ethernet sub-interface view is displayed.

  3. Run ip binding vpn-instance vpn-instance-name

    A VPN instance is bound to the sub-interface.

  4. Run ip address ip-address { mask | mask-length } [ sub ]

    An IP address is configured for the Ethernet sub-interface.

    NOTE:

    When two or more IP addresses are configured for an Ethernet interface, use sub to specify the second IP address and subsequent IP addresses.

  5. Run qinq termination pe-vid pe-vid ce-vid ce-vid1 [ to ce-vid2 ]

    The sub-interface is configured to terminate double-tagged packets.

    NOTE:
    • high-pe-vid is supported by only the AR3200-S.

    • You can specify high-pe-vid only after the termination-vid batch enable command is used to enable a sub-interface to batch terminate VLAN tags.

    • The value of high-pe-vid must be greater than or equal to the value of low-pe-vid.

    • When this command is executed on an Eth-Trunk sub-interface, you cannot specify high-pe-vid.

    • After a VLAN tag termination sub-interface is configured, ensure that ARP broadcast is enabled on the sub-interface. For details, see the arp broadcast enable command.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 56230

Downloads: 42

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next