No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a QinQ Termination Sub-interface and Connecting It to an L2VPN

Configuring a QinQ Termination Sub-interface and Connecting It to an L2VPN

When users are connected through an L2VPN and each packet that CEs send to PEs carries double VLAN tags, configure a QinQ termination sub-interface and connect it to the L2VPN.

Pre-configuration Tasks

Before configuring a QinQ termination sub-interface and connecting it to an L2VPN, complete the following tasks:
  • Connecting devices correctly
  • Configuring VLANs to which CEs belong and basic Layer 2 forwarding so that packets sent from CEs to PEs carry double VLAN tags

Procedure

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 56500

Downloads: 42

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next