No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for QinQ

Licensing Requirements and Limitations for QinQ

This section describes the points of attention when configuring QinQ.

Involved Network Elements


Licensing Requirements

QinQ is a basic feature of a router and is not under license control.

Feature Limitations

When deploying QinQ on the router, pay attention to the following:

  • Before configuring QinQ on an interface, add the interface to a network bridge. If the interface is deleted from the network bridge, the QinQ configuration is also deleted from the interface.
  • You can configure only QinQ, selective QinQ, or VLAN mapping on a sub-interface.

Only the AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S series routers support QinQ tunneling.

Only the AR1200-S, AR2200-S, AR3200-S series routers support termination sub-interface access to the VPN.

Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 55915

Downloads: 41

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next