No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
What Link Aggregation Modes Are Supported by the Device?

What Link Aggregation Modes Are Supported by the Device?

The following link aggregation modes are supported:

  • Manual load balancing mode: This mode allows you to manually add interfaces to an Eth-Trunk. All the member interfaces are in forwarding state and perform load balancing.
  • LACP mode: This mode allows the AR to select active links by negotiating parameters using LACP. In LACP mode, you need to manually set up an Eth-Trunk and add interfaces to the Eth-Trunk.
Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 55411

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next