No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009 CLI-based Configuration Guide - Ethernet Switching

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Transparent Transmission of BPDUs

(Optional) Configuring Transparent Transmission of BPDUs

Context

Some BPDUs sent out from an interface of a bridge group may be discarded during transmission by default. After the outbound interface added to the bridge group is enabled to transparently transmit BPDUs, BPDUs can be sent from this interface.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run bpdu transmit enable

    The interface is enabled to transparently transmit BPDUs.

    By default, a network bridge interface or an interface connected to a VLL is disabled from transparently transmitting BPDUs.

    NOTE:

    The command can only be used on Layer 3 interfaces.

  4. Run quit

    Return to the system view.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174108

Views: 62329

Downloads: 50

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next