Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MPLS TE
- Configuring a Static MPLS TE Tunnel
- Configuring a Dynamic MPLS TE Tunnel
- Configuring a Static DS-TE Tunnel
DS-TE provides QoS guarantee based on service types. A static DS-TE tunnel is easy to configure. It is established using labels that are allocated manually but not by a signaling protocol to send control packets. Therefore, fewer resources are consumed. - Configuring a Dynamic DS-TE Tunnel
- Importing Traffic to an MPLS TE Tunnel
- Adjusting RSVP-TE Signaling Parameters
- Adjusting the Path of a CR-LSP
- Adjusting the Establishment of an MPLS TE Tunnel
- Configuring CR-LSP Backup
- Configuring Manual TE FRR
- Configuring Auto TE FRR
- Configuring Association Between TE FRR and CR-LSP Backup
- Configuring Dynamic BFD for RSVP
- Configuring Static BFD for CR-LSPs
- Configuring Dynamic BFD for CR-LSPs
- Configuring Static BFD for TE Tunnels
- Configuring RSVP GR
