Configuring a Device to Communicate with an NMS by Running SNMPv3
Pre-configuration Tasks
To allow a device to communicate with an NMS running SNMPv3, configure SNMPv3 on the device. The SNMP parameters must be configured on both the managed device (agent) and NMS. This section describes only the SNMP configurations on the agent side. For details about SNMP configurations on an NMS, see the NMS operation guide.
Before configuring a device to communicate with an NMS by running SNMPv3, configure a routing protocol to ensure that at least one route exists between router and NMS.
Configuration Process
When you configure the device to communicate with the NMS using SNMPv3, Configuring Basic SNMPv3 Functions is mandatory and optional steps can be performed in any sequence.
The NMS using the specified community name can access the Viewdefault view. The internet MIB (OID: 1.3.6.1) and the lagMIB (OID: 1.2.840.10006.300.43) can be operated in this view.
The managed device sends traps generated by the modules that are enabled by default to the NMS.
To allow an NMS that uses a specified community name to manage specified objects on the device, perform the operations in Restricting Management Rights of the NMS.
To allow a specified module on the managed device to report traps to the NMS, perform the operations in Configuring the Trap Function.
If the NMS and managed device are both Huawei products, perform the operations in Enabling the SNMP Extended Error Code Function to allow the managed device to send more types of error codes. More error codes facilitate your fault location and rectification.