No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - QoS

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Displaying Statistics on Application Protocol Packets

Displaying Statistics on Application Protocol Packets

Prerequisites

SAC has been enabled and a signature file has been loaded.

Context

When the SA statistics function is enabled on an interface, you can check statistics on SA application protocol packets on the interface. You can also check the statistics on application protocol packets with the most number of bytes. The statistics help you learn information about application protocol packets and network usage.

Procedure

  1. Run the system-view command to enter the system view.
  2. Run the interface interface-type interface-number command to enter the interface view.
  3. Run the sa application-statistic enable command to enable the SA statistics function.
  4. Run the display sa application-statistic { application application-name | top-n number | all } interface { interface-type interface-number | virtual-template vt-number virtual-access va-number } [ inbound | outbound ] command to check statistics on packets of SA application protocols.

    After the reset session all command is used to delete all session table information, run the reset engine session table command to clear engine session information. Then you can collect statistics on application protocol packets.

    SA cannot identify a protocol of which a connection has been set up. To ensure that SA can identify the protocol, terminate the connection, and then establish the connection.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174115

Views: 39435

Downloads: 28

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next